I've tried the casting and the results are not good.
1. The pitcher pigments were gone.
2. Colors are gone as well.
3. The casting produce intnese heat during chemical reaction and this may harm the pitcher.
4. The resin are too sticky and hard to get rid if it once touched. I have to throw away all my mould after using one time. All things are dirty. The washer is hard to get. I can only get the right washer to wash my hands.
5. The resin and hardener ratio is 100:1. Too much hardener the casting will be too hot and crack while too few the casting won't be solidified. Hard to mix!
6. All the stuff has already been costing a few hundreds Ringgit. However I still have more than half of the stock to try.
It's still in the trial and error stage. I still wish to preserve my pitcher. Anyone who has such experience please kindly share it. David, you there? Any good guidance?
